Videotek VTM-2000 Specifications download pdf (Page 31)

Operation

VTM-200 Installation and Operation Handbook 3-15

Video Inputs

The VTM-200 accepts two video formats: composite and serial digital.

Selecting Video Inputs

Press INPUT next to the A, B, C, or D. Pressing the INPUT button will cycle through

a four-quadrant display:

• Full-screen display of the processing picture

• Full-screen waveform display

• Full-screen vector display

• (OPT-1 Option) Full-screen audio level display

NOTE: The video is in Parade mode. To change to Overlay mode, use the SETUP MENU.

Selecting Filters

There are three filters available: Flat, Low Pass, and Chroma. Press FILTER to select

the next filter. Multiple filters can function simultaneously. Only the FLAT selection

applies to the components of signals applied at the C or D video connectors. No

filtering is ever applied to the vector display.

Selecting Sweep Modes

Press SWEEP to select one of the four sweep modes: 1H (1 Horizontal), 2H

(2 Horizontal), 1V (1 Vertical), and 2V (2 Vertical). 1H or 1V SWEEP is possible when

paraded components have been selected for display, the only a 1H or 1V SWEEP is

possible. Overlaid components are shown in a 1H display, and paraded components are

shown in a 3H display. If LINE SELECT is set to ON, then only 1H sweep is possible.

Selecting a Display Format

Press FORMAT to select one of three display formats: RGB, YC

, and

COMPOSITE. Table 3-4 lists the relationships between the input and display formats:

Table 3-4. Input and Display Format Relationship

Input/Format RGB YC

Composite

No No Yes

Digital

Yes Yes Yes

1 Not available for RGB formats.

2 Available with YC input only.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

No comments

Videotek VTM-2000 Specifications Page 31