Videotek VTM-2000 Specifications download pdf (Page 203)

VTM Series Installation and Operation Handbook

7-1

Section 7 ♦ Troubleshooting

CAUTION — these instructions are for use by qualified personnel only. To reduce

the risk of electric shock, do not perform this installation or any servicing unless you

are qualified to do so. Refer all servicing to qualified service personnel.

NOTE: When power is applied to the unit, the display shows the startup screen for about 45 seconds.

If the VTM Series is not functioning properly, first verify that:

• The VTM Series is connected to a power source (90–264 VAC, 50/60 Hz nominal).

• All cables are correctly connected (see Section 2, “Installation”).

Initial difficulties with operation or display can be due to improper setup. Review the

SETUP MENU (see Section 3, “Operation”) to ensure that the proper adjustments have

been made for the signal requirements.

Cold Starting the VTM Series

NOTE: A cold start resets all front panel and Setup menu selections to the factory-default settings. All

user settings are lost. See Section 3, “Operation,” for the factory-default settings.

If a problem persists after the cables are correctly connected and the unit is set up,

perform a Cold Start. Two procedures can cold start the VTM Series. Only one

procedure needs to be performed to cold start the unit. The first type of cold start

procedure is a front panel Cold Start, as described below. The second type of cold start

procedure is a Warm Start that is described on page 7-2. The third type of cold start is

a Cold Start after a VFlash update that is described on page 7-2.

The Ethernet default settings for the VTM Series are:

• IP: 192.0.0.100

• Subnet Mask: 255.255.255.192

• Gateway: 0.0.0.0

Cold Start

The Front Panel Cold Start procedure is a cold starting procedure that does not require

the power to be disconnected from the unit. To perform a Front Panel Cold Start:

1. Push and hold the SETUP button, UP/DOWN knob, and RIGHT/LEFT knob. For a

minimum of five seconds. The Cold Start message appears on the screen.

2. Once the message appears, the cold start is complete.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 239 240

No comments

Videotek VTM-2000 Specifications Page 203