Videotek VTM-2000 Specifications download pdf (Page 22)

Installation

VTM-2000 Installation and Operation Handbook

2-4

Ethernet Setup

1. Prior to the VTM-2000 Network configuration, obtain Transmission Control

Protocol/Internet Protocol (TCP/IP) addresses from the System Administrator or

from the Internet Service Provider (ISP).

These addresses are:

• A static IP address (unless Dynamic Host Configuration Protocol (DHCP) will

be used)

• A Subnet Mask

• An optional Gateway IP

Be sure to record all addresses. The Gateway address is only needed if the

VTM-2000 is routed to an outside network.

Record the addresses:

VTM-2000 Interface Static IP Address

VTM-2000 Interface Subnet Mask

Gateway IP Address

2. Identify a host PC to configure and test the VTM-2000.

3a. For a dedicated PC connection, connect the host PC with a network card to the

“VFLASH” connector on the back panel of the VTM-2000, using a CAT5

crossover cable (not included). See Figure 2-3.

Figure 2-3. VTM-2000 Dedicated PC Connection

3b. For a network connection, connect the network hub to the back panel of the

VTM-2000 using a CAT5 network cable (not included). See Figure 2-4.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 115 116

No comments

Videotek VTM-2000 Specifications Page 22