Videotek VTM-2000 Specifications download pdf (Page 73)

Global Setup Menu Functions

VTM-2000 Installation and Operation Handbook

4-17

Screen Saver

The screen saver is used to provide a blank screen after there is no activity for the

specified duration. The time it takes for the screen saver to activate can range from 1

to 60 minutes. OFF disables the screen saver. When the screen saver is activated,

press any button to turn the display back on.

Output Level

The Output Level submenu is used to determine the monitor output level. The default

monitor output level is 1V p-p. The other output level selection is 0.7V p-p.

Time Code

Time Code is used to display the Time Code on the right side of the picture. The Time

Code can be displayed on the Top-right, Middle-right, or Bottom-right side of the

picture.

Communications Setup

The Communications Setup menu is used to configure the communication between the

VTM-2000 and any peripheral hardware and Software connected to the unit.

RCU Port

The RCU Port submenu controls the termination for the Remote Port on the back of the

VTM-2000.

Termination

One RCU-2000 connects to multiple VTM-2000 instruments using a multidrop straight

through wire with RJ-11 connectors (not a standard telephone wire) that connects to the

REMOTE ports on the back of the VTMs and to the TO MAIN UNIT connector on the

back of the RCU. All VTMs must have unique unit IDs, as described in Unit ID on

page 4-19. The REMOTE port must be terminated on the last VTM-2000 using this

menu.

IP Configuration

The IP CONFIGURATION menu is used to configure the VTM-2000 for Ethernet

communication. The Ethernet interface provides a high-speed communication link to

the VFlash application over standard LAN and Internet networks. The interface

conforms to industry Ethernet standards:

• Connection via a standard RJ45 socket

• Automatic detection and switching between 10BaseT and 100BaseT

• TCP/IP stack is fully compliant with RFC2500, “Internet Official Protocol

Standards”

• Fully compliant with the IEEE 802.3 Ethernet standard

The interface can accept a static IP address, or it can obtain an IP address dynamically

from a DHCP server. The IP Address, Subnet Mask, Gateway Address, and DHCP are

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 115 116

No comments

Videotek VTM-2000 Specifications Page 73