Videotek VTM-2000 Specifications download pdf (Page 23)

Installation

VTM-2000 Installation and Operation Handbook

2-5

Figure 2-4. VTM-2000 Network PC Connection

4. Ethernet Configuration

a) Press the SETUP/ENTER button on the VTM front panel.

b) Press the UP or DOWN button to highlight the COMMUNICATIONS menu,

and then press the SETUP/ENTER button to enter the submenu.

c) Press the UP or DOWN button until the IP CONFIGURATION submenu is

highlighted.

d) Press the SETUP/ENTER button to enter the IP CONFIGURATION submenu.

e) (If using DHCP) Turn the LEFT/RIGHT knob or press the SETUP/ENTER

button to highlight DHCP. Press the UP or DOWN button to toggle the state to

ON. Turn the LEFT/RIGHT knob or press the SETUP/ENTER button to

highlight ACCEPT, and then press SETUP/ENTER. The IP Address, Subnet

mask, and Gateway is retrieved from the DHCP server.

(If not using DHCP) Press the UP or DOWN button to change the value in the

first IP address box, and press the SETUP/ENTER button to highlight the next

value. Repeat for the remainder of the IP Address, Subnet Mask, and Gateway.

To avoid conflicts, the static IP Address, Subnet Mask, and Gateway should be

obtained from the System Administrator.

f) Press SETUP/ENTER button or turn the LEFT/RIGHT knob to highlight

ACCEPT, and press SETUP/ENTER to accept the entered values.

g) Press the EXIT button to exit the submenu.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 115 116

No comments

Videotek VTM-2000 Specifications Page 23