Videotek VTM-2000 Specifications download pdf (Page 24)

Installation

VTM-2000 Installation and Operation Handbook

2-6

Configuring the VTM/TVM Series with the RCU-2000 Remote

Control

For the following configurations, the interconnecting cables can be extended using

electronic distribution. There are two ways to configure the VTM-2000 Series with the

RCU-2000 remote control:

• One RCU-2000 connected to one VTM-2000 unit using the REMOTE port.

• One RCU-2000 connected to multiple VTM-2000 using a multidrop cabling

adaptor and straight through cable using RJ-11 connectors (not a standard

telephone wire) that connects to the REMOTE ports on the back of the VTM-2000

units and to the TO MAIN UNIT connector on the back of the RCU. All

VTM-2000 units must have unique unit IDs. The unit ID is the identification

number of the VTM-2000 units, and can be set to any number within a range of 1

to 99 in the COMMUNICATIONS menu. The unit IDs should be different than the

identification numbers of other units in the same system configuration. The

REMOTE port must be terminated on the last VTM-2000 unit, as shown in

Figure 2-5. The flat cable shown in Figure 2-5 is a straight through cable.

Figure 2-5. Connecting the RCU-2000 Remote Control Panel to Multiple VTM-2000 Units

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 115 116

No comments

Videotek VTM-2000 Specifications Page 24