Videotek VTM-2000 Specifications download pdf (Page 83)

VTM-2000 Installation and Operation Handbook

6-1

Section 6 ♦ Troubleshooting

CAUTION — these instructions are for use by qualified personnel only. To reduce

the risk of electric shock, do not perform this installation or any servicing unless you

are qualified to do so. Refer all servicing to qualified service personnel.

NOTE: When power is applied to the unit, the display shows the startup screen for about 25 seconds.

If the VTM-2000 is not functioning properly, first verify that:

• The VTM-2000 is connected to a power source (90–264 VAC, 50/60 Hz nominal).

• All cables are correctly connected (see Section 2, “Installation”).

Initial difficulties with operation or display can be due to improper setup. Review the

operation was correct to ensure that the proper adjustments have been made for the

signal requirements.

Cold Starting the VTM-2000

NOTE: A cold start resets all front panel and Setup menu selections to the factory-default settings. All

user settings are lost.

If a problem persists after the cables are correctly connected and the unit is set up,

perform a Cold Start. Three procedures can cold start the VTM-2000. Only one

procedure needs to be performed to cold start the unit. The first type of cold start

procedure is a front panel Cold Start, as described below. The second type of cold start

procedure is a Warm Start that is described on page 7-2. The third type of cold start is

a Cold Start after a VFlash update that is described on page 7-2.

The Ethernet default settings for the VTM-2000 are:

• IP: 192.0.0.100

• Subnet Mask: 255.255.255.192

• Gateway: 0.0.0.0

Cold Start

The Front Panel Cold Start procedure is a cold starting procedure that does not require

the power to be disconnected from the unit. To perform a Front Panel Cold Start:

1. Push and hold the EXIT button, PRESET button, and DOWN button. For a

minimum of five seconds. The Cold Start message appears on the screen.

2. Once the message appears, the cold start is complete.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 115 116

No comments

Videotek VTM-2000 Specifications Page 83